User Guide

Configuration figure
Local premisses
configuration
12 Configuration and Use - CIP & IP Routing
129 / 288
3EC 36231 ABAA TCZZA Ed. 01
12.2.7 Example Configuration
The configuration of a Classical IP LIS is illustrated with the
following example:
ETH
ATM ATM
ETH
Symbolizes an VP/VC cross-connect
10.0.0.2
255.0.0.0
10.0.0.138<-0.0.0.0
10.0.0.1
255.0.0.0
10.0.0.138<-0.0.0.0
10.0.0.138
255.0.0.0
172.16.1.2
255.255.255.0
192.168.0.1
255.0.0.0
192.168.0.2
255.255.255.0
0.0.0.0.->192.168.0.1
8/80
8/80
172.16.1.2<-0.0.0.0
172.16.1.1
255.255.255.0
10.0.0.0->172.16.1.1
LIS 172.16.1.x
Subnet 10.1
Local Servers
12
In the drawing above a LIS, 172.16.1.x, represented by the
ellipse, runs between the STPro(1) and access router(2).
At the local premisses an IP network, 10.x.x.x, is created.
An IP address is configured on the Ethernet port (10.0.0.138).
On the DSL side of the STPro(1) one CIP member is by default
enabled. This CIP member is configured with IP address
172.16.1.1 and is part of the LIS 172.16.1.x.
One VC in the STPro(1) phonebook (CIPPVC1), is explicitly
assigned to this CIP member. This VC(8/80) is crossconnected to
the remote destination.