User Guide

Introduction
Advanced routing
In this subsection
The 'Routing' tab
11 Configuration and Use - Routed PPPoA
109 / 288
3EC 36231 ABAA TCZZA Ed. 01
11.4.1 'Routing' Configurations
If a PPP session is opened successfully (either manually by the user,
triggered by LAN traffic or automatic at boot time) routes are
automatically added to the STPro's routing table.
The settings in the PPP 'IP Routing' box, are reflected in the routing
table.
For advanced users, the STPro allows manual configuration of
permanent routes to dedicated destinations.
See section 14.5 for more information on the STPro's IP router.
Moreover, routes can be configured via the CLI which will only be
added to the IP route table upon establishing the PPP connection.
See chapter 22 for more information on the CLI.
 'Routing' Tab
 Connection Sharing
 Connection Sharing Subnet Values
 'My net only' Configuration
 Destination Networks
 Destination Networks Subnet Values.
The following figure shows the 'Routing' tab: