User Guide
Access methods for PPP
PPPoA configuration
11 Configuration and Use - Routed PPPoA
101 / 288
3EC 36231 ABAA TCZZA Ed. 01
11.2 Using Routed PPPoA
Three methods exist to open a Routed PPPoA session:
Dialin
The session is opened manually
Alwayson
After the STPro is powered and finished its POST successfully,
the STPro automatically tries to open the session
Dialondemand
The session is opened automatically, triggered by the arrival
of packets at a/the STPro Ethernet port, destined for a Routed
PPPoA connection.
Per default, following Routed PPPoA connections are
preconfigured:
DIALUP_PPP1: dialin connection
DIALUP_PPP2: alwayson connection
DHCP_SPOOF: spoofing connection.
In case these entries do not meet your requirements, you can
configure a new one as follows:
1. If needed, add an PPPoA phonebook entry with the correct
VPI/VCI on the 'Phonebook' page.
2. On the 'PPP' page, select this phonebook entry from the
'Destination' popdown list.
3. For this entry, select PPPoA in the 'Protocol' field.
4. Select the correct encapsulation method from the
Encapulation' popdown list.
5. Optionally, enter username and password.
6. Click .
7. Optionally, perform detailed configurations.
See section 9.3 for more information.