User Guide
13 PPP Commands
213 / 260
3EC 16982 AFAA TCZZA Ed. 01
[qos] The name of a configured Quality Of Service book entry.
This parameter never needs to be specified.
OPTIONAL
[proto] The encapsulation method for the PPP frames, i.e. the applicable
packet service for the connection.
Select:
pppoa
For a Routed PPPoA (PPP & IP Routing) connections.
pppoe
For a Routed PPPoE connection.
Per default the PPPoA protocol applies.
OPTIONAL
[acname] The Access Concentrator name for a Routed PPPoE connection.
This parameter is applicable only for Routed PPPoE PPP interfaces
(proto=pppoe).
Execute the ppp ifscan command to see the names of available
access concentrators, if any.
OPTIONAL
[servicename] The Service Name for a Routed PPPoE connection.
This parameter is applicable only for Routed PPPoE PPP interfaces
(proto=pppoe).
Execute the ppp ifscan command to see the available service
names, if any.
OPTIONAL
[encaps] The type of encapsulation to be used for this PPP interface.
Choose between:
vcmux (default)
Standard encapsulation method for PPPoA (ppp) frames.
llc
Standard encapsulation method for ETHoA (bridge) frames.
OPTIONAL
[pcomp] Try (on) or do not try (off) to negotiate PPP protocol compression (LCP
PCOMP).
Per default the negotiation is disabled (off).
OPTIONAL
[accomp] Try (on), do never try (off) or negotiate (negotiate) to negotiate PPP
address & control field compression (LCP ACCOMP).
In the very most cases LCP ACCOMP should not be disabled nor
negotiated, i.e. the address field FF03 should not be sent over ATM.
Therefore by default this parameter is enabled (on).
In case the accomp parameter is set 'negotiate' the local side of the
PPP connection demands to do ACCOMP and adapts itself to the
result of this negotiation.
OPTIONAL
[trace] Enable (on) or disable (off) verbose console logging.
By default tracing is disabled (off).
OPTIONAL
[pap] Force PAP based authentication (on) or use CHAP based
authentication, if available (off).
For security reasons PAP negotiation is disabled (off) per default.
OPTIONAL
[restart] Automatically restart the connection when LCP link goes down (on) or
do not restart automatically (off).
By default restart is disabled (off).
OPTIONAL