User Guide

Chapter 3. Configuring Router Software 51
Configuring a Dual-Ethernet Router for IP Routing
This table outlines commands used to configure a Dual-Ethernet router for IP routing.
Dual-Ethernet Router with IP Routing
Steps Settings Commands
System Settings
System Name Optional
system name
<name>
System Settings
Message Optional
system msg
<message>
Ethernet Settings
Routing/ Bridging
Controls
Enable IP routing
Disable bridging
eth ip enable
eth br disable
ETH/0 IP Address Define ETH/0 IP address for
the hub side
eth ip addr
<ipaddr> <ipnetmask>
[
<port#>
]
ETH/1 IP Address Define ETH/1 IP address for
the single 10Base-T side
eth ip addr
<ipaddr> <ipnetmask>
[
<port#>
]
TCP/IP default route
address
ETH/0 sends all traffic to
ETH/1
eth ip addroute
<ipaddr> <ipnetmask> <gateway>
<hops>
[
<port#>
]
DHCP Settings
Already enabled; additional settings may be required
DHCP Settings Define DHCP network for
ETH/1
dhcp add | <
net> <mask>
|
<ipaddr>
|
<code>
<min> <max> <type>
Create an address pool for
ETH/1
dhcp set addresses
<first ipaddr> <last ipaddr>
DNS Domain Name
dhcp set valueoption domainname <
domainname
>
DNS Server
dhcp set valueoption domainnameserver
<ipaddr>
WINS Server Address
dhcp set valueoption winsserver
<ipaddr>