User Guide

Chapter 3. Configuring Router Software 47
Configuring RFC 1483 / RFC 1490 with Bridging
This table outlines configuration commands for the RFC 1483 and RFC 1490 Link Protocols with the Bridging
Network Protocol.
RFC 1483 / RFC 1490 with Bridging
Steps Settings Commands
System Settings
System Message Optional
system msg <
message
>
DHCP Settings Already enabled;
additional settings may be
required
dhcp set valueoption domainname <
domainname
>
dhcp set valueoption domainnameserver <
ipaddr
>
Change Login Optional
system admin <
password
>
Remote Routers
New Entry Enter: Remote Name
remote add <
remoteName
>
Link Protocol/PVC
(for ATM routers)
Select: RFC 1483
Enter: VPI/VCI Numbers
remote setProtocol RFC1483 <
remoteName
>
remote setPVC <
vpi number
>*<
vci number
>
<
remoteName
>
Link Protocol/DLCI
a
(for Frame Relay
routers)
a
Enter this information if you are using RFC 1490 in a Frame-Relay environment
.
Select: FR
Enter: DLCI number
remote setProtocol FR <
remoteName
>
remote setDLCI <
number
> <
remoteName
>
Bridging On/Off Must be on
remote enaBridge <
remoteName
>
IP and IPX Routing
IP Routing Must be disabled
eth ip disable
IPX Routing Must be disabled
eth ipx disable
Store
Reboot
save
reboot