User Guide

Chapter 3. Configuring Router Software 45
Configuring RFC 1483 / RFC 1490 with IP Routing
This table outlines configuration commands for the RFC 1483 and the RFC 1490 Link Protocols with the IP
Routing Network Protocol.
RFC 1483 / RFC 1490 with IP Routing
Steps Settings Commands
System Settings
System Message Optional
system msg <
message
>
Ethernet IP Address As required
eth ip addr <
ipaddr
> <
ipnetmask
>
[
<
port#
>]
DHCP Settings Already enabled;
additional settings may
be required
dhcp set valueoption domainname <
domainname
>
dhcp set valueoption domainnameserver <
ipaddr>
Change Login Optional
system admin <
password
>
Remote Routers
New Entry Enter: Remote Name
remote add <
remoteName
>
Link Protocol/PVC
a
(for ATM routers)
a Enter this information if you are using RFC 1483 in an ATM environment.
Select: RFC 1483
Enter: VPI/VCI
Numbers
remote setProtocol RFC1483 <
remoteName
>
remote setPVC <
vpi number
>*<
vci number>
<
remoteName
>
Link Protocol/DLCI
b
(for Frame Relay
routers)
b
Enter this information if you are using RFC 1490 in a Frame-Relay environment
.
Select: FR
Enter: DLCI number
remote setProtocol FR <
remoteName
>
remote setDLCI <
number
> <
remoteName
>
Bridging On/Off Must be OFF
remote disBridge <
remoteName
>
TCP/IP Route
Address
Enter: Explicit or default
route with remote
gateway
remote addiproute <
ipnet
> <
ipnetmask
> <
hops
>
<
remoteName
>
If Address Translation
(NAT) is enabled:
To enable NAT, use:
remote setIpTranslate on <
remoteName
>
TCP/IP Route
Addresses
Enter: Source WAN Port
Address
remote setSrcIpAddr <
ipaddr
> <
mask
> <
remoteName
>
If NAT is off:
TCP/IP Route
Addresses
You may still need to
enter a Source WAN
Port Address
remote setSrcIpAddr <
ipaddr
> <
mask
> <
remoteName
>
IP and IPX Routing
TCP/IP Routing
(Internet Firewall)
Must be enabled
(Optional)
eth ip enable
eth firewall <on | off >
IPX Routing Must be disabled
eth ipx disable
Store
Reboot
save
reboot