User Guide

42 Chapter 3. Configuring Router Software
Configuring PPP with IP Routing
This table outlines configuration commands for the PPP Link Protocol with the IP Routing Network Protocol.
PPP with IP Routing
Steps Settings Commands
System Settings
System Name Required
system name <
name
>
System Message Optional
system msg <
message
>
Authentication Password Required
system passwd <
password
>
Ethernet IP Address As required
eth ip addr <
ipaddr
> <
ipnetmask
>
[<
port#
>]
DHCP Settings Already enabled; additional
settings may be required
dhcp set valueoption domainname
<
domainname
>
dhcp set valueoption domainnameserver
<
ipaddr
>
Change Login Optional
system admin <
password
>
Remote Routers
New Entry Enter: Remote Name
remote add <
remoteName
>
Link Protocol/PVC
a
(for ATM routers)
a Enter this information if you are using PPP in an ATM environment.
Select: PPP
Enter: VPI/VCI numbers
remote setProtocol PPP <
remoteName
>
remote setPVC <
vpi number
>*<
vci number
>
<
remoteName>
Link Protocol/DLCI
b
(for Frame Relay routers)
b Enter this information if you are using PPP in a Frame Relay environment.
Select: PPP
Enter: DLCI number
remote setProtocol PPP <
remoteName
>
remote setDLCI <
number
> <
remoteName
>
Security
c
Remote’s Password
c If the ISP does not support the authentication of the ISP system by the caller, use the command
remote disauthen
<
remoteName
> to disable the authentication.
Choose security level
Enter: password
remote setAuthen <
protocol>
<
remoteName
>
remote setOurPasswd <
password
> <
remoteName
>
Bridging On/Off Must be off
remote disBridge <
remoteName
>
TCP/IP Route Address Enter: Explicit or default
route
remote addIproute <
ipnet
> <
ipnetmask
> <
hop
s
>
<
remoteName
>
If NAT is enabled: To enable NAT, use:
remote setIpTranslate
on
<
remoteName
>
You may need to enter a
Source WAN Port Address
remote setSrcIpAddr <
ipaddr
> <
mask
>
<
remoteName
>
If NAT is not enabled: You may need to enter a
Source WAN Port Address
remote setSrcIpAddr <
ipaddr
>
<mask
>
<
remoteName
>
IP and IPX Routing
TCP/IP Routing
(Internet Firewall)
Must be enabled
(optional)
eth ip enable
eth firewall <
on | off
>
IPX Routing Must be disabled
eth ipx disable
Store
Reboot
save
reboot