User Guide

250 Appendix A. Network Information Worksheets
Configuring RFC 1483MER / RFC 1490MER with IP Routing
RFC 1483MER/RFC 1490MER with IP Routing
Steps Commands Your Settings
System Settings
System Message
system msg <
message
>
....................................................
Ethernet IP Address
eth ip addr <
ipaddr
> <
ipnetmask
>
[<
port#
>] ....................................................
DHCP Settings
dhcp set valueoption domainname <
domainname
>
dhcp set valueoption domainnameserver <
ipaddr
>
....................................................
Change Login
system admin <
password
>
....................................................
Remote Routers
New Entry
remote add <
remoteName
>
....................................................
Link Protocol/PVC
a
(for ATM routers)
a Enter this information if you are using RFC 1483 in an ATM environment.
remote setProtocol RFC1483MER
<
remoteName
>
remote setPVC <
vpi number
>*<
vci number
>
<
remoteName
>
....................................................
Link Protocol /DLCI
b
(for Frame Relay
Routers)
b Enter this information if you are using RFC 1490 in a Frame-Relay environment.
remote setProtocol MER <
remoteName
>
remote setDLCI <
number
><
remoteName
>
....................................................
Bridging On/Off
remote disBridge <
remoteName
>
....................................................
TCP/IP Route
Address
remote addIproute <
ipnet
>
<
ipnetmask
><
ipgateway
> <
hops
>
<
remoteName
>
....................................................
If NAT is enabled:
To enable NAT,enter:
-and-
Enter a Source WAN
Port Addr
remote setIpTranslate on <
remoteName
>
remote setSrcIpAddr <
ipaddr
> <
ipnetmask
>
<
remoteName
>
c
c The mask is the mask of the remote network.
....................................................
If NAT is not enabled:
You may need to enter
a Source WAN Port
Addr
remote setSrcIpAddr
<
ipaddr
> <
ipnetmask
>
<
remoteName
>
d
d The mask is the mask of the remote network.
....................................................
IP and IPX Routing
TCP/IP Routing
(Internet Firewall)
eth ip enable
eth ip firewall
<on | off>
....................................................
IPX Routing
eth ipx disable
....................................................
Store
Reboot
save
reboot