User Guide

182 Chapter 5. Command Line Interface Reference
SDSL ?
Lists the supported keywords.
SDSL SPEED
CO end: Sets the speed manually on the Central Office (CO) end only.
CPE end: The router on the Customer Premises End (CPE) end is always in auto-speed mode: it uses an auto-
speed algorithm to attempt to match the CO speed. The command
sdsl speed noauto
is used to override auto-
speed.
Note 1:
The command
sdsl speed
(with no option) displays the current speed if the modem has activated
successfully.
Note 2: sdsl speed noauto
should be followed by the command
sdsl save
to be persistent across reboots.
Note 3:
During auto-speed search, use the command
sdsl speed <
speed
>
to stop the search and restart it at the
speed you just entered.
sdsl ?
Example:
sdsl ?
Response:
SDSL commands:
speed stats terminal
sdsl speed
[192 | 384 | 768 | 1152 | noauto]
384 Default speed for the CO.
192, 768, 1152 Authorized non-default speeds for the CO in Mbps. This will vary on SDSL model type.
noauto Used to override auto-speed on the CPE.
Example:
sdsl speed 1152
sdsl speed noauto
sdsl speed