User Guide

180 Chapter 5. Command Line Interface Reference
ISDN SET SWITCH
Specifies link speeds of 64, 128, or 144 Kbps for the IDSL connection.
REMOTE SETDLCI
This command allows the user to set the Data Link Connection Identifier—an address identifying a logical
connection—in a Frame-Relay environment. This number is generally provided by the Network Service Provider.
REMOTE SETPROTOCOL
This IDSL-specific command is used to select the appropriate link protocol for your IDSL connection. Your
Network Service Provider will tell you which link protocol to use.
Example:
isdn save
isdn set switch
[FR64 | FR128 | FR144]
FR64 Link speed of 64 Kbps
FR128 Link speed of 128 Kbps
FR144 Link speed of 144 Kbps
Example:
isdn set switch fr144
remote setDLCI
<
dlcinumber
> <
remoteName>
dlcinumber
Frame-Relay number identifying the data-link connection.
remoteName
Name of the remote router (character string).
Example:
remote setDLCI 16 HQ
remote setProtocol
[PPP | FR | MER] <
remoteName>
PPP PPP protocol with no encapsulation.
FR RFC 1490 protocol (Multiprotocol encapsulation over Frame Relay).
MER RFC 1490 protocol with MAC Encapsulated Routing.
remoteName
Name of the remote router (character string).
Example:
remote setProtocol FR HQ