User Guide

172 Chapter 5. Command Line Interface Reference
Dual-Ethernet Router Commands (ETH)
The following Ethernet commands are used to manage the Ethernet interfaces for the Dual-Ethernet (Ethernet-to-
Ethernet) router and thus are
specific to this type of router only
.
Note:
For non-specific Ethernet commands, refer to
Target Router Ethernet LAN Bridging and Routing (ETH), on
page 134
.
General information
This Dual-Ethernet router may be configured via the Web Browser GUI or from the Command Line Interface
(CLI). You will need to use the CLI to set up any DHCP options as well as to configure optional features like
IP filtering.
The Dual-Ethernet router has two interfaces:
ETH/0 = Hub with four 10Base-T connectors
ETH/1 = Single 10Base-T connector
Note 1:
For configuration information, refer to the
Customer Release Notes
provided with the Dual-Ethernet
router.
Note 2:
If you use the
Boot from Network
option from the boot menu to perform a boot code update or
install a software key option, the boot request is sent from the ETH/0 interface only.
ETH BR ENABLE
Enables bridging in a Dual-Ethernet environment. This command requires rebooting the router for the change to
take effect.
ETH BR DISABLE
Disables bridging in a Dual-Ethernet environment.
Note:
This command requires rebooting the router for the change to take effect.
eth br enable
Example:
eth br enable
eth br disable
Example:
eth br disable