User Guide

Chapter 5. Command Line Interface Reference 161
REMOTE SETIPSSLAVEPPP
If SetIPSlaveModePPP is yes the router will accept the IP address that the remote end informs the router that it
has without reguard to how the router was previously configured. If setIPSlaveModePPP is no the router will try
to use the address that it was configured for.
Normally there is no need to change the default (no) value of this option, however, in certain situations where the
router is managed by another party, (as part of a managed service), it might make sense to set this value to yes to
ensure that the central management site always specifies the IP address of the router.
REMOTE SETIPTRANSLATE
This command is used to control Network Address Translation on a per remote router basis. It allows several PCs
to share a single IP address to the Internet. The remote router must assign the source WAN IP address to the
routers’ local WAN port. This command requires that you define a Source WAN IP Address with the command:
remote setSrcIpAddr
REMOTE SETIPXADDR
Sets the IPX network number for the remote WAN connection.
REMOTE SETL2TPCLIENT
This command is specific to L2TP tunnel configuration. Please, refer to the L2TP commands section, L2TP —
Virtual Dial-Up Configuration (L2TP), on page 196, for more usage information.
remote setIPsslavePPP
yes|no
<remoteName>
remote setIPTranslate
on|off
<remoteName>
remoteName
Name of the remote router (character string).
Example:
remote setIPTranslate on HQ
remote setIpxaddr
<
ipxNet
> [
port#
]
ixpNet
IPX network number represented by 8 hexadecimal characters.
port#
Port number of the Ethernet LAN. This number must be either 0 or it may be omitted.
Example:
remote setIpxaddr 789 HQ
remote setl2tpclient
<TunnelName><remoteName>