User Guide

Chapter 5. Command Line Interface Reference 121
Target Router System Configuration Commands (SYSTEM)
The following commands set basic router configuration information:
• name of the router
• optional system message
• authentication password
• security authentication protocol
• management security
• system administration password
• IP address translation
• NAT configuration
• host mapping
• WAN-to-WAN forwarding
• filters
SYSTEM ?
Lists the supported keywords.
SYSTEM ADDHOSTMAPPING
This command is used to remap a range of local-LAN IP addresses to a range of public IP addresses on a
system-
wide basis
. These local addresses are mapped one-to-one to the public addresses.
Note:
The range of public IP addresses is defined by <
first public addr
> only. The rest of the range is computed
automatically (from
<first public addr
> to
<first public addr>
+ number of addresses remapped - 1) inclusive.
system ?
Response:
? msg name
passwd authen community
list admin history
log addHostMapping delHostMapping
addServer delServer bootServer
supportTrace telnetport snmport
syslogport addTelnetFilter delTelnetFilter
addSNMPFilter delSNMPFilter addSyslogFilter
delSyslogFilter wan2wanforwarding OneWANdialup
blockNetBIOSDefault addUDPrealy delUDPrelay
securityTimer