User Guide

5 Troubleshooting
E-SIT-CTC-20030306-0004 v2.0
71
How to perform a
hardware reset to
factory defaults
Proceed as follows:
1 Put DIP switch number 4 in the UP position:
You will notice that the PWR/Alarm LED flashes red.
2 Power cycle the SpeedTouch™610 and wait to allow it to restart.
The SpeedTouch™610 will come online with manufacturing defaults.
3 Reset the DIP switch in its original position. If not, the PWR/Alarm LED will flash
red as a warning.
Note Leaving the DIP switch in the UP position, will cause unintended reset
to manufacturing defaults!
4 A reset to factory default settings also deletes the configuration profile settings.
Therefore, a reconfiguration via the SpeedTouch™ Setup wizard or via uploading
the appropriate configuration file might be needed. See “1.3 SpeedTouch™610
Configuration Setup” on page 10 for more information.
For more information on the operation and management of the SpeedTouch™610, see
the application note “SpeedTouch™610 Operation and Management”.
Config Console