User Guide

Alcatel Wireless Quick Start Guide 7
Sample Master Configuration
Enter system name [Alcatel_4324]:
Enter VLAN 1 interface IP address [172.16.0.254]: 10.200.14.6
Enter VLAN 1 interface subnet mask [255.255.255.0]:
Enter IP Default gateway [none]: 10.200.14.1
Enter Switch Role, (master|local) [master]:
Enter country code (ISO-3166), <ctrl-I> for supported list: US
You have chosen Country code US for United States (yes|no)?: yes
Re-type Password for admin login: Confirm the password entry. If you
re-type the password differently
from the initial entry, the system
will prompt you:
Passwords were not the same!
Please re-enter
Enter password for enable mode Create the Enable mode password.
The administrator must be able to
access this mode to access the
configuration commands.
Re-type password for enable mode Confirm the Enable mode pass-
word. If the two entries do not
match, the system will prompt you
:
Passwords were not the same!
Please re-enter
Do you wish to shutdown all the ports
(yes|no)? [no]:
Typically, you should answer
no to
enable all ports, set them to
trusted mode, and assign them to
VLAN 1. If you select
yes, all the
ports will be disabled.
Current choices are: Set up Dialog will confirm your set-
tings.
Do you wish to accept the changes
(yes|no)
If you select yes, the system will
reboot to this new configuration.
If you select
no, the Setup Dialog
will restart from the beginning. If
you need to just change a selec-
tion, press
ctrl-P to step back
through the Setup Dialog prompts
until you come to the prompt
answer you wish to change.