User Guide

OmniAccess RF Plan User Guide: User Guide
40 Part 031649-00 May 2005
Click the Initialize button.
You will see a total of 5 AP symbols appear on the two floor diagrams, 3 on
Floor 1 and 2 on Floor 2. You will also notice that the Suggested Access Points
tables below each floor diagram have been populated with information about
the suggested APs for each corresponding floor.
Click the Start Button.
After you Initialize the APs you must start the algorithm. You will see the APs
move around on the floor plans as the algorithm is running.
The algorithm will stop when the movement is less than a threshold value
calculated based on the number of APs. The threshold value may be seen in
the status bar at the bottom of the browser window.
NOTE—To see the approximate coverage areas of each of the APs, select an AP
type from the Approx. Coverage pull-down box and select a rate from the
Coverage Rate pull-down box.
Click Save, then click the AM Planning button.
Running the AM Plan
Running the AM Plan algorithm is exactly like running the AP Plan above.
Click on Initialize.
Click on Start.
The algorithm will stop when the movement is less than a threshold value
calculated based on the number of AMs. The threshold value may be seen in
the status bar at the bottom of the browser window.
Click Save.
1
2
3
1
2
3