User Guide

OmniAccess RF Plan User Guide: User Guide
38 Part 031649-00 May 2005
Using your mouse, left-click and drag the box over the Shipping
and Receiving area.
Drag one corner of the box to a corresponding corner of the Shipping and
Receiving area and using one of the corner handles of the box, stretch it to fit
exactly over the Shipping and Receiving area.
Your floor plan with the Don’t Care box should look similar to this:
Click Save.
Create a Don’t Deploy Area
Click the “New” link in the Areas box located below the lower
left corner of the floor plan in the AP Planning window.
Ty p e Lobby in the Name text box in the Area Editor.
Select “Don’t Deploy” from the Type pull-down menu box.
Click the Apply button.
Notice that an yellow box appears near the center of the floor plan.
Use your mouse (or other pointing device) to place the cursor
over the box.
Notice that the information you typed in the editor appears in the box. You will
see the name and type of area, as well as the coordinates of the lower left
corner and upper right corner of the box.
N
OTE—The x = 0 and y = 0 coordinates correspond to the lower left corner of
the layout space.
7
8
1
2
3
4
5