User Guide

OmniAccess RF Plan User Guide: User Guide
22 Part 031649-00 May 2005
z Image Scaling
Images are scaled (stretched) to fit the display area. The display area aspect
ratio is determined by the building dimensions specified on the Dimension page.
Area Editor Page
The area editor allows you to specify areas on your buildings floors where you
either do not care about coverage, or where you do not want to place an AP or
AM.
Open the Area Editor by clicking on the New link in the Areas field just below
the area where the background image is displayed.
You specify these areas by placing them on top of the background image using
the Area Editor.
Naming
You may name an area using an alpha-numeric string of characters with a
maximum length of 64 characters. You should give areas some meaningful
name so that they are easily identified.
Locating and Sizing
You may specify absolute coordinates for the lower left corner and upper right
corner of the box that represents the area you are defining. The datum for
measurement is the lower left corner of the rectangular display area that
represents your building’s footprint. The coordinates of the upper right-hand
corner of the display area are the absolute (no unit of measure) values of the
dimensions you gave your building when you defined it with the dimension
feature.
N
OTE—The location is zero-based. Values range from 0 to (height - 1 and width
- 1).For example: If you defined your building to be 200 feet wide and 400
feet long, the coordinates of the upper right-hand corner would be (199,
399).
Area Editor “New” Link