User Guide

The External Services Interface 61
Chapter 7
4Click
Add button in the Server groups section to configure a server group. If
a group exists and needs to be edited, click
Edit for the group. Provide a
name to the group and map the required health check profile to this server
group.
5Click Done to accept this configuration.
6Click
Add in the Security Servers section to add a AntiVirusFirewall (AVF)
server device/server.
z Provide a name to the device/server.
z Assign this server to a group from the existing configured groups.
z Choose the mode as bridge/route as the topology may require. Refer to
the description above to understand the differences between the two
modes.
z If the bridge mode is chosen, enter the trusted port and un-trusted port
as defined above in the description above.
z If the route mode is chosen, enter the IP addresses of the trusted and
un-trusted interfaces on the AntiVirusFirewall (AVF) server device as
defined above.
7Click
Done to accept this configuration.
8Click Apply to apply the configuration (changes). Note that the configura-
tion will not take effect till this step is completed.