User Guide

Adding a Local Switch 33
Chapter 5
When prompted to enter the operational mode in the setup dialog, enter
local to set the switch operational mode to be a local switch.
You are then prompted for the master switch IP address. Enter the IP address
of the master switch of the Wireless LAN network.
Using the Web UI
Once the switch is up and operation with Layer-3 connectivity, the following
needs to be configured to set the switch up as a local switch:
z The mode of the switch has to be set to local.
Enter system name [Alcatel4324]:
Enter VLAN 1 interface IP address [172.16.0.254]: 10.200.14.6
Enter VLAN 1 interface subnet mask [255.255.255.0]:
Enter IP Default gateway [none]: 10.200.14.1
Enter Switch Role, (master|local) [master]: local <-----
Enter Master switch IP address: 10.4.21.10 <-----
Enter password for admin login (up to 32 chars): *****
Re-type Password for admin login: *****
Enter password for enable mode (up to 15 chars): ******
Re-type password for enable mode: ******
Do you wish to shutdown all the ports (yes|no)? [no]:
Current choices are:
System name: Alcatel4324
VLAN 1 interface IP address: 10.100.2.30
VLAN 1 interface subnet mask: 255.255.255.0
IP Default gateway: 10.100.2.1
Switch Role: local
Master switch IP address: 10.200.14.6
Ports shutdown: no
If you accept the changes the switch will restart!
Type <ctrl-P> to go back and change answer for any question
Do you wish to accept the changes (yes|no)y
Creating configuration... Done.
System will now restart!