User Guide

OmniAccess RN: User Guide
30 Part 031650-00 May 2005
Configure the APs with the appropriate Virtual-IP address depending on which
switch is expected to control the AP. As an example, the administrator can
configure such that all APs on floor 1 are controlled by local switch 1, all APs
on floor 2 are controlled by local switch 2 and so on. All the local switches are
backed up by the master switch as shown above. In such a case, configure all
APs on floor 1 to be controlled by the Virtual IP address of the VRRP between
local switch 1 and master and so on. This can be done by following these
steps:
The following example shows how these steps are used to configure the APs on
floor 1 of building 1 to use the pair of switches configured in the above example.
N
OTE—This command is executed on the Master switch.
(Alcatel4324) (config) #ap location 1.1.0
(Alcatel4324) (sap-config location 1.1.0) #lms-ip 10.200.11.254
(Alcatel4324) (sap-config location 1.1.0) #
Command Explanation
Expected/recommend
ed values
Step 1 ap location b.f.l Choose the APs to
configure by using the
location code in the
building.floor.location
format.
Depending on the set of
APs to be configured,
enter the location code
using 0 as a wild card
value. As an example all
APs on building 1 and
floor 1 can be
represented by the
location code 1.1.0.
Step 2 lms-ip ip-address Configure the IP
address of the switch
controlling the APs
chosen
Configure this IP address
to be the same as the
Virtual IP address for the
VRRP instance between
the appropriate local
switch and master
switch.