User Guide

OmniAccess RN: User Guide
28 Part 031650-00 May 2005
4 Use the following steps to configure VRRP on the master and local
switches respectively. Note: the master switch will be configured for a
number of VRRP instances (equal to the number of local switches the mas-
ter is backing up).
Command Explanation
Expected/Recommen
ded Values
Step 1 vrrp vrrp-id Creates the VRRP
instance.
It is recommended to
configure the VRRP ID to
be the same as VLAN ID
on which the instance
runs for easier
administration and
maintenance.
Step 2
vlan vlan-id Associates the
VRRP instance with
a VLAN.
VLAN ID from step 2
above.
Step 3
ip address ip-address Virtual IP address
for the VRRP
instance
Virtual IP address from
step 2 above.
Step 4 Priority priority-value Priority of the VRRP
instance that is
used in the election
of the master. By
default, the value is
100.
The following are the
recommended values for
the priority on the
master and local
switches:
Master: 100
Local: 110.
Step 5 Preempt Enable preemption