User Guide

OmniAccess RN: User Guide
20 Part 031650-00 May 2005
4 Configure the values in the respective fields as shown in the table above
and click Add to enter the values.
5Click
Apply to apply the configuration and add the VRRP instance.
Enable Router
Pre-emption
Selecting this option means
that a switch can take over
the role of master if it detects
a lower priority switch
currently acting as master
For this topology it is
recommended NOT to select
this option.
Priority Priority level of the VRRP
instance for the switch. This
value is used in the election
mechanism for the master
It is recommended to leave this
as the default for this
topology.(default = 100).
Admin State Administrative state of the
VRRP instance
To start the VRRP instance,
change the admin state to UP.
VLAN VLAN on which the VRRP
protocol will run.
Configure this to be the VLAN
ID from step i.