User Guide

Configuring Network Parameters 15
Chapter 3
To change the switch loopback IP address:
1. Navigate to the
Configuration > Switch > General page on the WebUI.
2 Modify the loopback IP address in the Loopback Interface section on this
page as required. Click Apply to apply this configuration.
3 Navigate to the
Maintenance > Switch > Reboot page to reboot the switch to
apply the change of loopback IP address
4Click
Continue to save the configuration.
CAUTION—If you are using the loopback IP address to access the
WebUI, this will result in loss of connectivity. Alcatel recommends
that you use one of the VLAN interface IP address to access the
WebUI to make this change.