User Guide

OmniAccess RN: User Guide
14 Part 031650-00 May 2005
Configuring Static Routes
1. Navigate to the Configuration > Switch > IP Routing page.
2Click
Add to add a static route to a destination network or host. Enter the
destination IP and network mask (255.255.255.255 for a host route) and
the next hop IP address.
3Click
Add to confirm the entry.
NOTE— The route has not yet been added to the routing table.
Click Apply to add this route to the routing table. The message Configuration
Updated Successfully
will confirm that the route has been added.
Modifying the Loopback IP Address
NOTE—This procedure requires a switch reboot.