User Guide

OmniAccess RN: User Guide
12 Part 031650-00 May 2005
NOTE—Make sure that the Port Mode is Access in the Configure Selected Ports sec-
tion.
3Click Apply to make this configuration active.
NOTE—This will apply the entire configuration shown in the Configure Selected Ports
section, including changes that were not explicitly made. Make sure that the con-
figuration for all items on the list is as desired before clicking
Apply.
4 Verify that the Configuration was applied by navigating to the Configuration
> Switch > VLAN
screen. The port configured should be shown as a member
of the configured VLAN.
Configuring a Trunk Port
An in-band Ethernet port can be configured to be a trunk port and a member of
multiple VLANs using the following steps: