User Guide

OmniAccess RN: User Guide
10 Part 031650-00 May 2005
2Click Add to create a new VLAN. To edit an existing VLAN click Edit for this
VLAN. On the next screen (as shown below), enter the VLAN ID, the IP
address and network mask of the VLAN interface. If required, the address of
the DHCP server for that VLAN can also be configured by clicking
Add.
The VLAN can be assigned to the required ports by selecting the appropri-
ate boxes in the
Assign this VLAN to Ports fields. However, the recommended
procedure for assigning VLANs to ports is explained in the following sec-
tion.
3Click
Apply to apply this configuration.
4 Verify that the VLAN has been created on the VLAN page.