User Guide

Configuring Network Parameters 9
CHAPTER 3
Configuring Network Parameters
This section outlines the steps involved to configure the various
network parameters required to set up an Alcatel Mobility
Controller. This includes configuring VLANs, IP interfaces, static
routes, and loopback IP addresses.
Conceptual Overview
The concept of VLAN is used in the Alcatel Mobility Controller as
a layer 2 broadcast domain as well as a layer 3 IP interface, similar
to most layer 2/3 switches. The administrator can configure a set
of ports to be members of a VLAN and define an IP
address/netmask for the VLAN interface. A single physical port
can be a member of multiple VLANs by use of 802.1q
trunking/tagging.
The loopback IP address is a logical IP interface that is used by
the Alcatel Mobility Controllers and APs to communicate
amongst each other. To make use of this interface, ensure that
the IP address is reachable through one of the VLAN interfaces.
The examples and configuration guidelines below will illustrate
the same.
Network Configuration
Create/Edit a VLAN
1. Navigate to the Configuration > Switch > VLAN page on the
WebUI.