User Guide

OmniAccess RN: User Guide
252 Part 031650-00 May 2005
26 Rogue AP detection and classification is enabled by default. To enable the
feature that disables users from connecting to Access Points that have
been identified as Rogue Access Points, go to
Configuration > Wireless LAN
Intrusion Detection > Rogue AP
and select Disable Users from Connecting to
Rogue Access Points as shown in Figure 18-18 below.
FIGURE 18-18 Configuring Rogue APs
27 Click Apply to apply this configuration.
CAUTION—Be careful when enabling both Mark Unknown APs as Rogue
and Disable Users from Connecting to Rogue APs. If the system is
installed in an area where APs from neighboring locations can be
detected, these two options will disable all APs in the area.