User Guide

Topology Example Three 245
Chapter 18
10 To enable the APs to accept associations from clients, configure the Max
Clients value on the
Wireless LAN > Radio > 802.11b/g page. (Configure the
same on 802.11a page if you are also using 802.11a clients).
FIGURE 18-7 Configuring Radios
11 Apply this configuration to enable Access Points to accept associations.
12 For the RADIUS server configuration, the client IP address is the interface
IP address of the interface that connects the Alcatel Mobility Controller to
the RADIUS server.
In this example, VLAN 14 is that interface. Therefore, the client IP address for
the RADIUS server configuration is the IP address of the VLAN 14 interface
(10.200.14.6).
The NAS-IP-Address
1
is the loopback IP address or the IP of the Alcatel
Mobility Controller. In this case the value of this IP address is 10.200.14.14.
13 Configure the roles and their associated privileges for the users authenti-
cated using 802.1x and the guest users (authenticated by using guest
logon on captive portal).
14 Create a role called authenticated-user on the
Configuration > Security > Role
page and configure it to have all privileges by adding the pre-defined policy
called allowall to the list of policies for this role.
1.Effective with AOS-W 2.4 and higher, you can configure the NAS-IP-Address attribute per RA-
DIUS server (as opposed to one NAS IP address per system). This means you can configure a
Wireless LAN environment with multiple RADIUS servers, each owned by a different ISP.