User Guide

Secure Remote Access Points 15
Chapter 2
z Add the entry for the username/password used for authentication by
Secure Remote Access Point Service to the authentication server.
Configure the NAT device to which the switch connects (deployment scenario
3 only).
These steps are explained below:
1. Configure the AP with the master address, username and password
authentication.
All AP60/61 and AP70 Alcatel Access Points can be provisioned to offer
Secure Remote Access Point Services. The easiest way is to use the Program
AP Web configuration page to configure the AP settings.
z Once the AP boots up, it will appear as an un-provisioned AP if it is a
new AP. If the AP is an already provisioned AP which has to be re-con-
figured to provide Secure Access Point Services, continue with the
next step. Otherwise, navigate to the
Wireless LAN > Program AP > Provi-
sion AP
page and provision the AP as you would a regular AP with its
location and master IP. Apply the changes and reload the AP. This step
ensures that the AP now boots with the 2.4 code (or higher) that sup-
ports this feature.
Deployment Scenario
Master IP Address Value while
Provisioning the AP
Deployment 1 Alcatel Mobility Controller IP address
Deployment 2 Alcatel Mobility Controller public IP address
Deployment 3 Public address of the NAT device to which the
Alcatel Mobility Controller is connected.