User Guide

Topology Example Two 227
CHAPTER 17
Topology Example Two
The example included in this chapter require that the Alcatel
Mobility Controller has been set up according to the instructions
in the Quick Start Guide. These examples use specific Alcatel
Mobility Controllers and Access Points. However, these
configurations are valid for all Alcatel Mobility Controllers (6000,
4324, and 4308) and for all Alcatel Access Points (APs)
(AP52/60/61), unless explicitly mentioned otherwise.
This example is based on a topology which has the following
characteristics:
z Indirectly connected APs (Layer 3 connected to the Alcatel
Mobility Controller).
z No location specific configuration for Access Points.
z ADP enabled and configured in the network.
z Employee/guest roles.
z Employees authenticating using 802.1x, and
z Guests using guest logon using captive portal and using
static WEP encryption.