User Guide

OmniAccess RN: User Guide
194 Part 031650-00 May 2005
All the above parameters can also be configured for a subset of all the Access
Points in the Alcatel network by using the location code of the Access Points
in the building.floor.location format. The administrator can use 0 as the wild
card value for any of the fields in this format. As an example, all APs in building
10 can be represented by the location code 10.0.0. To configure the SNMP
parameters for a set of APs, follow these steps:
1. Navigate to
Configuration > Wireless LAN > Advanced page on the WebUI of
the Master switch
2 If the required set does not exist, click
Add to add the set of APs repre-
sented by a location code (using 0 as the wild card value when required as
explained above). If the set already exists, click Edit for the chosen set and
proceed to step 4 to configure the SNMP parameters for the chosen set.
3Click
Add to complete adding the location.