User Guide

OmniAccess RN: User Guide
190 Part 031650-00 May 2005
network using SNMP. The SNMP configuration for the Access Points can be
done at a global level (thereby being applicable for all the Alcatel Access Points
in the network) as well as for a particular set of Access Point(s) by using the
AP location codes. The steps required for each type of configuration is
explained below. Note: The configuration for Access Points is always done on
the Master switch only.
Follow the steps below to configure SNMP parameters for Access Points in
the network at a global level:
1. Navigate to the Configuration > Wireless LAN > Network > General page on the
WebUI of the Master switch. This page includes fields for configuring the
SNMP parameters on all Access Points in the network.