User Guide

Intrusion Detection 179
Chapter 13
Configuring Ad-hoc Network Protection
The table below describes the parameters in this section.
Configuring Wireless Bridge Detection
To configure detection of wireless bridges, navigate to Configuration > Wireless
LAN Intrusion Detection > Policies > Wireless Bridge
, as shown in the figure
below.
The table below describes the fields in this section.
Misconfigured AP Protection: To configure protection of misconfigured APs,
navigate to
Configuration > Wireless LAN Intrusion Detection > Policies >
Misconfigured AP,
as shown in the figure below
Field Description
1. Enable Adhoc Networks
Activity Detection
Enable detection of Ad-hoc networks.
2. Enable Adhoc Network
Protection
When Ad-hoc networks are detected, they
will be disabled using a denial of service
attack.
3. Adhoc Detection Quiet Time
(secs)
After an alarm has been triggered, the
amount of time that must pass before
another identical alarm may be triggered.
Field Description
1. Enable Wireless Bridge
Detection
Enable detection of Ad-hoc networks.
2. Wireless Bridge Detection
Quiet Time (secs)
After an alarm has been triggered, the
amount of time that must pass before
another identical alarm may be triggered.