User Guide

OmniAccess RN: User Guide
176 Part 031650-00 May 2005
2 Enter a name for the newly added signature pattern in the Signature Name
field and select the Signature Mode option to enable detection for this sig-
nature (leave this field disabled if only creating a signature but enabling
detection at this point).
3Click
Add to add a signature rule.
4In the
Add Condition section, add a rule that matches an attribute to a value.
The attribute can be one of the following:
z BSSID: This refers to the BSSID field in the 802.11 header of frames.
z Destination MAC address: This refers to the Destination MAC address in
802.11 header of frames.
z Frame Type: This refers to the type of 802.11 frame. For each type of frame
further details can be specified to filter and detect only the required frames.
It can be one of the following:
z Association
z Auth
z Control
z Data
z Deauth
z Deassoc
z Management
z Probe-request
z Probe-response
z Beacon.