User Guide

OmniAccess RN: User Guide
144 Part 031650-00 May 2005
To enable VPN authentication:
1. Navigate to the
Configuration > Security > Authentication Methods > VPN
Authentication
page.
2 Select the Authentication Enabled checkbox to enable VPN authentication.
3 Choose the default role for the users from the pull down menu for
Default
Role
.
4Set
Authentication Failure Threshold for Station Blacklisting to an integer value.
This number indicates the number of contiguous authentication failures
before the station is blacklisted.
5Click
Apply to apply the settings and to avoid loss of work. To save the
configuration between reloads, click the Save tab on the left hand top cor-
ner.
The Authentication server which the switch will use to authenticate the VPN
users needs to be configured. To configure the authentication server:
1. Navigate to the
Configuration > Security > Authentication Methods > VPN
Authentication
page.
2Click
Add under Authentication Server to add a RADIUS server.
3 From the pull down menu select the radius server that will be the primary
authentication server. Click
Add after making the choice.
4 To add multiple auth servers repeat steps above for each server.