User Guide

OmniAccess SafeGuard Controller Installation Guide

Chapter 2: Site Preparation and Installation

■ RS-232 (DB-9) configuration cable

■ Mounting accessories, including:

— Four rubber feet for installing the SafeGuard Controller on a table

— Two brackets for installing the SafeGuard Controller in a rack

— Six Phillips screws for attaching the brackets to the SafeGuard Controller

■ Disposable ESD wrist strap

■ SFP modules and cables as determined when the SafeGuard Controller was

ordered

Installing the SafeGuard Controller on a Table or Shelf

To install the SafeGuard Controller on a table or shelf, follow these steps:

1 Lift the controller carefully from the packing material and place it upside down

on a flat surface.

2 Locate the recessed areas on the bottom of the controller, and attach the four

rubber feet from the mounting kit.

3 Place the controller on a table or shelf close to an AC power source.

For the ACDC model, an additional 48-VDC power source should be available.

For instructions on connecting the power cords, see Connecting Power to the SafeGuard

Controller on page 29.

Installing the SafeGuard Controller in a Rack

You can attach the rack-mounting brackets to the SafeGuard Controller in either of the

following positions:

■ At the front of the controller to install it in a four-post rack

■ At the middle of the controller to install it in a two-post (telco-type) rack

NOTE: You must provide rack-mounting screws appropriate to your

equipment rack and the cable for use with the DC terminal plug.