User Guide

OmniAccess SafeGuard OS Administration Guide
98
Chapter 2: Accessing and Managing the System
protection-mode mode all
The following example sets the SafeGuard Switch to protect mode:
(SafeGuardOS) #configure terminal
(SafeGuardOS) (config) #protection-mode protect all
Enabled: All SafeGuard security features
(SafeGuardOS) (config) #exit
(SafeGuardOS) #
Displaying Protection Mode Information
Use the show protection-mode command to verify the protection mode setting. The
following sample output is representative from a SafeGuard Controller:
(SafeGuardOS) #show protection-mode
Interface Protection Mode port type
--------- --------------- ---------
0/1 Protect network
0/2 Protect host
0/3 Protect network
0/4 Protect host
0/5 Protect network
0/6 Protect host
0/7 Protect network
0/8 Protect host
0/9 Protect network
0/10 Protect host
0/11 Protect network
0/12 Protect host
0/13 Protect network
0/14 Protect host
0/15 Protect network
0/16 Protect host
0/17 Protect network
0/18 Protect host
0/19 Protect network
0/20 Protect host
Syntax Description mode The protection mode of the port-pair. Valid
values are:
■ Pass-thru – (Default) No protection
policies are employed.
■ Monitor – The system monitors for policy
visualization based on user-defined
policy controls, however no
enforcement actions are taken.
■ Protect – The system monitors and
enforces policies on user-defined and
malware policy controls.