User Guide

OmniAccess SafeGuard OS Administration Guide
97
Chapter 2: Accessing and Managing the System
The following example sets ports 1 and 2 to protect mode, in Global Configuration mode:
(SafeGuardOS) #configure terminal
(SafeGuardOS) (config) #interface 0/1
(SafeGuardOS) (interface 0/1) #protection-mode protect all
(SafeGuardOS) (interface 0/1) #exit
(SafeGuardOS) (config) #exit
The following example sets the protection-mode globally (on all ports).
(CS106) #configure terminal
(CS106) (config) #protection-mode protect all
Enabled: All SafeGuard security features
(CS106) (config) #
Another example showing protection mode settings follows:
(SafeGuardOS) #show protection-mode
Interface Protection Mode port type
--------- --------------- ---------
0/1 Protect network
0/2 Protect host
0/3 Protect network
0/4 Protect host
0/5 Protect network
0/6 Protect host
0/7 Protect network
0/8 Protect host
0/9 Protect network
0/10 Protect host
0/11 Protect network
0/12 Protect host
0/13 Protect network
0/14 Protect host
0/15 Protect network
0/16 Protect host
0/17 Protect network
0/18 Protect host
0/19 Protect network
0/20 Protect host
0/21 Pass-thru network
0/22 Pass-thru host
0/23 Pass-thru network
0/24 Pass-thru host
(SafeGuardOS) #
For the SafeGuard Switch
For the SafeGuard Switch, device protection mode is set on a global basis. Individual
interfaces cannot be configured with different protection modes. Use the protection-
mode command in Global Configuration mode.