User Guide

OmniAccess SafeGuard OS Administration Guide
94
Chapter 2: Accessing and Managing the System
no monitor session sessionID destination interface
Restoring the Default Mirror Session Mode
To restore the default mirror session mode value for all configured sessions and remove
all source and destination ports, use the
no monitor command in the Global
configuration mode.
no monitor
This command has no parameters.
Showing the Monitor Session
To display port monitoring information for a particular mirroring session, use the show
monitor session
command in the Privileged Exec mode.
show monitor session sessionID
Syntax Description source
interface
slot/port
Specifies the interface to monitor. The no
form of the command removes the
specified interface from the port
monitoring session.
rx (Optional, for Switch only) Monitor only
ingress packets. If neither rx or tx is
chosen, both ingress and egress packets
will be monitored.
tx (Optional, for Switch only) Monitor only
egress packets. If neither rx or tx is
chosen, both ingress and egress packets
will be monitored.
destination
interface
slot/port
Interface to receive the monitored traffic.
The no form of the command does not
specify the slot/port; see syntax example.
mode Enable or disable (using the no form of the
command) the administrative mode of the
session. If enabled, the probe port monitors
all the traffic received and transmitted on
the monitored port.
Syntax Description sessionID An integer value used to identify the
session. Its value can be anything between
1 and the maximum number of mirroring
sessions allowed on the platform.