User Guide

OmniAccess SafeGuard OS Administration Guide
82
Chapter 2: Accessing and Managing the System
Displaying Ethernet Interface Information
To display the Ethernet interface information for the device, use the show interface
ethernet command. This command displays a summary of statistics for a specific port or
a count of all CPU traffic based on the argument.
show interface ethernet [slot/port | switchport]
The following example is representative of the show interface ethernet command:
(SafeGuardOS) #show interface ethernet 0/21
Total Bytes Received: 0
Packets Received > 1522 Octets: 0
Packets RX and TX 64 Octets: 0
Packets RX and TX 65-127 Octets: 0
Packets RX and TX 128-255 Octets: 0
Packets RX and TX 256-511 Octets: 0
Packets RX and TX 512-1023 Octets: 0
Packets RX and TX 1024-1518 Octets: 0
Packets Received: 0
Unicast Packets Received: 0
Multicast Packets Received: 0
Broadcast Packets Received: 0
Total Packets Received with MAC Errors: 0
Jabbers Received: 0
Fragments/Undersize Received: 0
FCS Errors: 0
Overruns: 0
Total Received Packets Not Forwarded: 0
Local Traffic Frames: 0
802.3x Pause Frames Received: 0
Unacceptable Frame Type: 0
VLAN Membership Mismatch: 0
VLAN Viable Discards: 0
Multicast Tree Viable Discards: 0
Reserved Address Discards: 0
Broadcast Storm Recovery: 0
CFI Discards: 0
Upstream Threshold: 0
Time Since
Counters Last
Cleared
The elapsed time, in days, hours, minutes, and seconds since the
statistics for this port were last cleared.
Syntax Description slot/port Displays information for a specific interface.
switchport Displays statistics for the entire switch.
Table 9 Show interface Option Descriptions (continued)
Option Description