User Guide

OmniAccess SafeGuard OS Administration Guide
79
Chapter 2: Accessing and Managing the System
Resetting the Device
To reset the SafeGuard device without powering it off, use the reload command in
Privilege Exec mode. A reset means that all network connections are terminated and the
boot code executes.
The device uses the stored configuration to initialize itself. When prompted to confirm
that the reset should proceed, enter y for Yes. The LEDs on the device indicate a
successful reset.
reload
Configuring Data Traffic Ports
This section describes the commands used for configuring the device port on the device.
See the following sections for more details:
■ Entering Interface Configuration Mode
■ Enabling and Disabling an Interface
■ Displaying Interface Information
■ Displaying Ethernet Interface Information
■ Understanding Mirroring and Monitoring Ports
■ Configuring Port-Based Mirroring
■ Changing the Protection Mode of Ports
Entering Interface Configuration Mode
To enter into interface configuration mode, use the interface command in Global
Configuration mode using the following syntax:
interface
[slot/port | vlan id id | vlan name name]
Syntax Description slot/port Slot/port format for interface.
vlan id Keyword for configuration of a VLAN
interface by ID.
vlan name Keyword for configuration of a VLAN
interface by name.
id ID of VLAN interface to configure.
name Name of VLAN interface to configure.