User Guide

OmniAccess SafeGuard OS Administration Guide
75
Chapter 2: Accessing and Managing the System
Displaying SNMP Target Information
To display the SNMP target information, use the show snmp-server target command.
show snmp-server target
The following sample output is representative of the show snmp-server target command:
(SafeGuardOS) #show snmp-server target
Trap Community IP Address Version Status
------------------- ----------------- -------------- --------
private 172.16.3.77 snmpv2 Enable
public 172.16.3.77 snmpv2 Enable
Alcatel-Lucent 172.16.3.77 snmpv2 Enable
Alcatel-Lucent 172.16.3.103 snmpv2 Enable
apple 172.16.3.115 snmpv2 Enable
orange 172.16.3.115 snmpv2 Enable
(SafeGuardOS) #
Ta ble 7 describes the output displayed with the show snmp-server target command.
Displaying SNMP System Information
To display the SNMP information, use the show snmp-server sysinfo command.
show snmp-server sysinfo
The following example is representative of the show snmp-server sysinfo command:
Access
Mode
Access level for this community string, valid entries are read only and
read/write.
Status Status of this community access entry, either enabled or disabled.
Table 7 Parameters Displayed with the show snmp-server target Command
Option Description
SNMP Trap
Community
Displays the name of an SNMP trap community.
IP Address Displays the IP address assigned to a specified community name.
Status One of two modes, either enabled or disabled.
Table 6 Parameters Displayed with the show snmp-server community
Command
Option Description