User Guide

OmniAccess SafeGuard OS Administration Guide
46
Chapter 2: Accessing and Managing the System
Clearing All Passwords
To clear all user passwords and reset them to the factory defaults (null) without powering
off the device, use the clear pass command in Privileged Exec mode. When prompted to
confirm that the password reset should proceed, enter y for Yes.
clear pass
The following example clears all user passwords and reinstates the system defaults:
(SafeGuardOS) #clear pass
Are you sure you want to reset all passwords? <n/y> y
Passwords reset
(SafeGuardOS) #
Managing Out-of-Band Management Port
This section describes the tasks and commands used for configuring and displaying
information for the out-of-band management port on SafeGuard devices. The
management port is also referred to as the service port.
See the following sections for more details:
■ Setting the IP Configuration Protocol
■ Enabling or Disabling the Management Port
■ Setting Speed and Duplex for the Management Port
■ Displaying Configuration Information for the Management Port
Setting the IP Configuration Protocol
To set the configuration protocol for the management port, use the serviceport protocol
command in Global Configuration mode.
When using this command, it is suggested to run the command twice: once with the
value
none, and once with the value desired for the management port’s protocol support
(either
bootp or dhcp). When modified, the change takes effect immediately.
For more details on bootstrap and DHCP protocols, see Configuring Bootstrap or DHCP
Relay on page 194.
serviceport protocol [none | bootp | dhcp]
Syntax Description none Specifies no protocol.
bootp Specifies BOOTP as the protocol.