User Guide

OmniAccess SafeGuard OS Administration Guide
42
Chapter 2: Accessing and Managing the System
abcd Exec Read Only None None
priv-user Exec Read Only None None
(SafeGuardOS) #
The fields in the output represent:
Setting a Password for the Default Admin Account
To set the password for the default administrator (admin) account, use the aaa mgmt-
user passwd admin
command. If a user is authorized for authentication or encryption
is enabled, the password must be at least eight alphanumeric characters in length.
The username and password are not case sensitive. When a password is changed, a
prompt asks for the former password. If none exists, press the Enter key. Use the no
version of the command to set the password to blank.
aaa mgmt-user passwd admin passwd
no aaa mgmt-user passwd admin passwd
The following example sets the default password to f00onU2:
(SafeGuardOS) #configure terminal
(SafeGuardOS) (config) #aaa mgmt-user passwd admin f00onU2
Password Changed!
(SafeGuardOS) (config) #exit
(SafeGuardOS) #
NOTE: SafeGuard OS will support SNMPv3 will be supported in a future
release.
Field Description
User Name Username as detected by its authentication.
User Access Mode The user’s access mode.
SNMPv3 Access Mode The SNMPv3 access mode.
SNMPv3 Authentication Whether the user has SNMPv3 authentication.
SNMPv3 Encryption Whether the user has SNMPv3 Encryption.
Syntax Description passwd Specifies the new password.