User Guide

OmniAccess SafeGuard OS Administration Guide
389
Chapter 11: Troubleshooting
Displaying the Logging Level
To display the currently configured trace and syslog levels, use the show logging
configuration command in Privileged Exec mode.
show logging configuration
The command has no parameters or variables.
The following example is representative of the command output:
(SafeGuardOS) #show logging configuration
Command Logging Level
-------------- ----------
ENABLED INFO
Remote Facility
---------------
local0
Module SYSLOG CONSOLE BUFFER
LOG TRACE LOG TRACE LOG TRACE
------------ ------------------- ------------------- -------------------
AUTH DEBUG DEBUG INFO DEBUG DEBUG
CFGM INFO CRITICAL INFO INFO CRITICAL
CLI INFO CRITICAL INFO INFO CRITICAL
EPV INFO INFO INFO
HIGHAVAIL INFO CRITICAL INFO INFO CRITICAL
HOST INFO INFO INFO
HWMON INFO CRITICAL INFO INFO CRITICAL
ICC INFO CRITICAL INFO INFO CRITICAL
IPC INFO CRITICAL INFO INFO CRITICAL
LSP INFO CRITICAL INFO INFO CRITICAL
LSPD INFO CRITICAL INFO INFO CRITICAL
MALWARE INFO CRITICAL INFO INFO CRITICAL
PLATFORM INFO CRITICAL INFO INFO CRITICAL
POLICY INFO INFO INFO INFO CRITICAL
PORTMON INFO CRITICAL INFO INFO CRITICAL
PROMAN INFO CRITICAL INFO INFO CRITICAL
TRAPMGR INFO CRITICAL INFO INFO CRITICAL
USERMGR INFO CRITICAL INFO DEBUG DEBUG
VIZ INFO CRITICAL INFO INFO CRITICAL
ADDRESS PORT
----------------- ----
172.16.137.21 514
172.16.197.10 514
Terminal Monitor State
----------------------
(SafeGuardOS) #