User Guide

OmniAccess SafeGuard OS Administration Guide
355
Chapter 9: End Point Validation
Restoring the Policy Default Configuration File
To restore the policy file to the factory default settings, use the following command in
Privileged Exec mode:
copy nvram:ics-policy-default nvram:ics-policy
This command has no options or parameters.
Backing Up and Restoring the ICS Gateway Configuration
Alcatel-Lucent recommends backing up the ICS gateway configuration, also called the
portal configuration. This configuration is made on the ICS Gateway Page and should be
changed as follows:
■ Require integrity security scanner
■ Allow access to endpoints running a non-supported OS
■ Enforce interval scan
Set a scan interval that is 15 minutes or longer and ensure that a corporate security
compliance policy is selected from the drop down list. Do not check the last two boxes
(Require Integrity Secure Workspace and Require Advanced Anti-keylogger). After being
set in ICS, you can save these settings in an optional backup file (portal.xml) in NVRAM
or on a TFTP server.
See the following sections for more details:
■ Copying and Saving Portal Settings
■ Restoring the Portal Backup File
■ Restoring the Portal Default Configuration File
Copying and Saving Portal Settings
To copy and save the portal settings, use the following command:
copy nvram:ics-portal [[tftp://ipaddr/ filename]| [nvram:ics-portal-
backup]
]
Syntax Description ipaddr Specifies that the ICS gateway configuration is
saved to the root directory of an TFTP server at this
IP address.
filename Specifies the ICS gateway configuration saved on
the TFTP server.
ics-portal-
backup
Specifies that the ICS gateway configuration is
saved in non-volatile memory, NVRAM.