User Guide

OmniAccess SafeGuard OS Administration Guide
210
Chapter 6: Configuring Authentication and Role Derivation
In the detail mode the following additional information is shown:
To see the l2-interface information, use the show host l2 interfaces Privileged Exec
command. To see all of the entries in the table, enter the command without any options.
show host l2 interfaces {[ip-address ipaddr] | [mac-address macaddr] |
[
port-number slot/port] | [vlan vlanid] | [hostname host]}
Field Description
MAP Source LSP for mappings learned based on traffic, DHCP for
mappings learned based on DHCP.
Ed. Note:
Configured Role This is the role derived from role derivation. It is also
displayed in the brief output.
Effective Role This is the role that policy has used for enforcement. It
may be different than the configured role based on
misconfiguration.
HA State ADDED indicates the interface has been seen and
processed, REMOVED indicates the interface has been
removed by this peer, and is waiting for an
acknowledgement from the other peer. PENDING
TRAFFIC indicates that this interface was learned from a
peer which subsequently failed, and this device is
waiting for traffic from the interface before marking it
active.
EPV Posture Either "healthy" or "unknown" based on the results of the
EPV scan.
EPV State "discovered" indicates that this host has started the scan
process, "postured" indicates the host has finished being
scanned, "unknown" indicates that the host has not
engaged with the EPV feature.
EPV Scan Started/Refresh Time when the EPV scan was started (host first was
redirected to scan page) and the last refresh was
processed.
Syntax Description ipaddr IP address of the mapping.